System isn't working?
System isn't working?

You don't have to own an American Standard Heating & Air Conditioning system to use our troubleshooter. If you're having a problem with your system, try these simple tips.

How it works:

Find your problem category below.
When you get to your problem, check for each sign and follow the path to the end.
If you find that the information listed below isn't solving your problem, contact a dealer or other licensed heating and cooling profession

No cooling
Check for signs: Possible cause: Possible remedy:
Check for open doors or windows in your home. If you find open doors or windows... Close them! Cool air may be escaping through them.
Check to see if your thermostat is on, and what temperature it's set at. If your thermostat is turned off or set incorrectly... Turn on and/or reset thermostat.
Check your home's circuits and fuse box. If you have an open circuit breaker or burned-out fuse... Switch on circuit or replace fuse.
Hold your hand in front of your indoor vents. Do you feel air, but air that hasn't been cooled? This usually means that your indoor unit is running, but not your outdoor unit. If this is the case... You might have a frozen line between your fan and compressor.

Temporary solution:
Turn off your thermostat and leave it off for 1-3 hours.

Permanent solution:
Contact your dealer

No airflow
Check for signs: Possible cause: Possible remedy:
Check to see if there is any air coming through your vent. Your indoor blower may not be operating. If this is the case... Contact your dealer.
Check around your outdoor unit. If there are any leaves, hedges or property walls butting up against it... Your system may have frozen up due to a dirty coil.
Make sure your outdoor unit has 1' of clearance all around it.
Contact your dealer for repair.
Check the filters in each of your system components. If any of your filters are dirty... Determine which of your filters is a problem. Consult your manual to clean or replace it. Or call your dealer to do this for you.

My utility bills seem unusually high
Check for signs: Possible cause: Possible remedy:
Consider whether you have new appliances (e.g. a hot tub or pool heater) that might be using lots of power. -- It may not be your heating and cooling system that's raising your bills.
Check to see if your local utility company had a recent rate increase. -- It may not be your heating and cooling system that's raising your bills.
Check to see that your system is cycling constantly.
Check to see that your thermostat is reaching its set value. If your system IS cycling constantly, and IS reaching its set point... This usually means that your system's working fine, but your local temperatures are constantly in the extreme, so your system's working extra hard to meet that set point.
If your system IS cycling constantly, but ISN'T reaching its set point... Contact

My equipment runs all the time
Check for signs: Possible cause: Possible remedy:
Check the set point on your thermostat. If your thermostat is set unusually low (summer) or unusually high (winter)... Your system may be trying to reach a set point that is too extreme.
Reset thermostat or contact your dealer.
back to top
My system is making noise
Check for signs: Possible cause: Possible remedy:
-- -- Contact your dealer.
back to top
Various components of my system fail pretty regularly
Check for signs: Possible cause: Possible remedy:
-- -- Contact your dealer.
Chris green says: 2011-05-30 01:27:20
Compressor is locked up. Anyway to unlock it

Comments: 1
Votes:4